We created this page to help you set up your utilities in the Descent 3 world. If you cannot find the information here check in the forum or the Rookie Area of chat.

-nointro Skips the intro movie when starting the game.
-nooutragelogo Disables the Outrage logo that is normally displayed for five seconds at the start of a MP game.
-nosparkles Disables powerup sparkles (Pentium III/4 only).
-nomotionblur Disables motion blur on robots (Pentium III/4 only).
-playermessages Disables all weapon-related HUD messages in multiplayer games.
-subpixelcorrect Adjusts for subpixel correction under Direct3D for cards that do not support it.
-bumped Enables hardware bump-mapping on cards that support it (D3D only). -z32bit Enables the 32-bit z-buffer on cards that support it.
-framecap 0 Remove the default framecap of 50 FPS.
-usesmoothing Enables code to smooth the interpoloation for fast-moving objects.
-deadzone0 0.0 Specifies the size of the deadzone for joystick 1.
-deadzone1 0.0 Specifies the size of the deadzone for joystick 2.
-nocompress Turns off S3TC texture compression for cards that support it.
-pilot [NuB2]Badboy Specifies the pilot to use, skipping the pilot selection dialog when the game starts.

Are you tired of turning Descent on every time and having to say no I don't want to register. Well I have found a way that it will never happen again. Heres how you do it.
1.Click on the Drive you installed Descent on.
2.Click on the Games folder.
3.Click on the Descent 3 folder.
4.Click on the ereg folder.
5.Open the ERegUI notepad
6.Find [Register Function] and replace Run=Yes to Run=No